We have had reports of an issue with the debugger sometimes fails to start under Windows 10. If you do not see an entry, then the USB driver has not been installed correctly. You will need to use AVR Studio 6.2 to upgrade its firmware. If you have an AVR Dragon, and if you see an entry “AVRBLDR”, then the AVR Dragon is in the bootloader mode. On the left pane, you should see an entry for “AVR Dragon”, “JTAGICE mkII”, “JTAGICE3 CMSIS-DAP” or “Atmel-ICE CMSIS-DAP” or something similar depending on what pod you have. To further resolve the issues: run c:\iccv8avr\.bin\UCView.exe. If you used the pod with AVR Studio 4.x previously, you will have to update the firmware the pod.įor AVR Dragon and JTAGICE MkII, did you install the filter driver? No driver needed for LINUX or MacOS Windows Driver Includes Programmer and custom 10 pin to 6 pin. Confirm that the target device is attached to the debug pod and powered.Ĥ. USBasp USB-ISP-Programmer for ATMEL AVR and Arduino. Confirm that the pod is plugged in the USB port and the power on light is lit.Ģ. However, in rare occasions, you might receive an error message such as “USB Command Timeout” or similar messages. If you follow the instructions above, you should not have any issues using the JumpStart Debugger.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |